SKU: 61918681745

BetaFPV SuperD ELRS Diversity Receiver - 2.4GHz

Sale price$23.39 Regular price$25.99
Save 10%

Pay in installments of $6.50 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 26 - Jul 31

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

BetaFPV SuperD ELRS Diversity Receiver - 2.4GHzBETAFPV SuperD ELRS is the first True Diversity Receiver that applies two antennas, dual receiver chains, and TCXO (temperature compensated crystal oscillator) tech, achieving a super accurate frequency rate and excellent performance in extreme temperature environments. It offers 2. 4GHz and 915MHz 868MHz versions, and greatly fulfills the requirements of reliability for long range flying, aerial photography, or FPV freestyle tricks. Check out all our

BETAFPV SuperD ELRS is the first True Diversity Receiver that applies two antennas, dual receiver chains, and TCXO (temperature compensated crystal oscillator) tech, achieving a super accurate frequency rate and excellent performance in extreme temperature environments. It offers 2.4GHz and 915MHz/868MHz versions, and greatly fulfills the requirements of reliability for long-range flying, aerial photography, or FPV freestyle tricks.

Check out all our Receivers and the rest of our BetaFPV Products!

A ton of ExpressLRS items are available now!


Bullet Points

  • A true diversity receiver with two complete RF receiver chains (referring to dual SX1280/SX1281 or dual SX1276), based on the latest official ExprssLRS. It comes with ExpressLRS V3.0.0 firmware.
  • Ultralight weight is only 1.1g without the antenna. The receiver board features a reasonable layout and is impeccably clean. Very easy to solder.
  • Two Dipole T antennas will create an omnidirectional signal for good signal transmission. Placing the antenna separately and vertically as far apart as possible to get a better signal is recommended.
  • Not only it is used for FPV drones but also for FPV fixed-wing, or other FPV aircraft. It has superb performance in long-range flying.
  • The first true diversity receiver for the 915MHz/868MHz frequency bands, with two separate receiving modules working together to improve signal reception quality and overall reliability.
  • The 900MHz radio system exhibits greater diffraction ability due to its lower frequency, while the 2.4GHz systems tend to be directional and susceptible to attenuation caused by buildings, foliage, or moisture.

Specification

  • Item: BETAFPV SuperD ELRS 2.4GHz Diversity Receiver
  • MCUESP32 PICO D4, dual SX1280(SX1281) (2.4GHz)
  • Telemetry power: 20dBm (2.4GHz
  • Weight excluding antenna: 1.1g (2.4GHz
  • RF Frequency: 2.4GHz (ISM) 
  • Antenna connector: IPEX MHF 1/U.FL
  • Input voltage: +5V DC @ “+” pad
  • Receiver protocol: CRSF
  • PCB size: 22mm x 14mm

First True Diversity Receiver with TCXO

SuperD ELRS 2.4GHz Diversity Receiver is built-in a TCXO (temperature compensated crystal oscillator), which is shared by two RF chips for a super accurate clock source. The true diversity receiver including two RF chips and PA+LNA will generate a large amount of heat when working. With the high-quality TCXO, it can withstand extreme temperatures with no fear of heat and cold, continuously outputting accurate frequency for long-range flight. 

BETAFPV ExpressLRS Receivers

SuperD ELRS 2.4GHz Diversity Receiver has dual RF receiver chains with two antennas, ensuring longer and more stable flying for FPV drones and RC airplanes. Choosing a suitable receiver to fly quadcopter or other RC models is very important. BETAFPV ExpressLRS Receivers including ELRS Lite, Nano, Micro, and the newest SuperD, greatly fulfill pilots' requirements for FPV flying.


SuperD RX Micro RX Nano RX Lite RX
Weight

1.1g (2.4GHz)1.2g (915/868MHz)

3.5g (RX only) 0.7g (RX only) 0.47g (Tower), 0.53g (Flat)
Antenna IPEX MHF1 + T antenna IPEX MHF1 + T antenna IPEX MHF1 + T antenna SMD ceramic antenna
MCU ESP32-PICO-D4 ESP8285
ESP8285
ESP8285 
RF Chip

Dual SX128X + Dual PA (2.4GHz), Dual SX1276 (915/868MHz)

SX128X SX128X + PA, SX1276 + PA SX128X
Frequency 2.4GHz ISM, 915MHz (FCC), 868MHz (EU) 2.4GHz ISM 2.4GHz ISM, 915MHz (FCC), 868MHz (EU)
2.4GHz ISM
Telemetry Power 100mW 17mW 100mW 17mW
Serial Output Protocol CRSF PWM or CRSF CRSF CRSF
Model Type FPV Drone, Fixed-wing aircraft Fixed-wing aircraft, Helicopter, RC Cars, RC Boats FPV Drone Whoop Drone

Diagram

The SuperD receiver 2.4GHz version diagram is shown below.


SuperD receiver RGB status indication is shown below.

RGB Color Status Description
Rainbow Fade effect Power on
Green Slow flash WIFI upgrading mode
Red Quick flash No RF chip detected
Orange Double flash Binding mode
Orange Triple flash Connected, but mismatched model-match configuration
Orange Slow flash Waiting for connection
Solid on Connected and color indicates packet rate

The RGB light color corresponding to the packet rate is shown in the figure below.

2.4GHz:

Note: F1000 and F500 are packet rates in FLRC mode, providing faster modulation and lower latency, but at the same time having shorter reception distance than normal Lora mode. This mode is great for racers.

D500 and D250 are packet rates in DVDA (Deja Vu Diversity Aid) mode. This mode works at the F1000 data packet rate of FLRC mode, providing better link connection in the case of complex interference by sending the same data packet multiple times. D500 and D250 indicate that the same data packet is sent twice and four times respectively.

915MHz/868MHz:

Note: D50 is a unique mode of ELRS Team900. Under the 200Hz refresh rate of Lora mode, the same data packet is repeatedly sent four times, and the receiving distance is equivalent to 200Hz.

100Hz Full is a mode that realizes 16-channel full-resolution output at the 200Hz refresh rate of Lora mode, and the receiving distance is equivalent to 200Hz.

Configuration & Bind

ExpressLRS uses the Crossfire serial protocol (AKA CRSF protocol) to communicate between the SuperD diversity receiver and the flight controller board. Take the flight controller using the Betaflight firmware as an example to introduce its wiring and port configuration. 

The connection between the SuperD diversity receiver and the flight controller is shown in the figure below

Connect the flight controller to the Betaflight Configurator for basic configuration. First, on the "Port" page, enable the flight controller serial port (take UART1 as an example) as "Serial Rx". 

On the configuration page, set Receiver Mode to Serial (via UART) and Serial Receiver Provider to CRSF.

The default firmware of the SuperD diversity receiver uses the ExpressLRS V3.0.0 protocol and has no preset binding phrase.  Therefore, the firmware version of the transmitter module must be ExpressLRS V3.0.0 or later versions. Both the receiver and transmitter module should not have any binding phrase.

  • Power on and off the receiver 3 times, each step pausing 2 seconds to enter binding mode;
  • When the indicator starts fast blink with orange twice, the receiving is at binding mode;
  • Enter the radio or transmitter module's binding mode to bind with the receiver; if the Indicator has turned solid, it indicates that the device has been bound successfully.

Note: After binding once, the receiver will remember the autosaved binding phrase and device. Further restarting of the device will be bound automatically without the need for a rebinding process.


The 2.4GHz default firmware is ELRS V3.0.0. If you would like to bind with a remote control or transmitter module, please upgrade it to V3.0.0 or above. If you would like to flash the latest official ELRS firmware for the SuperD receiver, please upgrade ELRS Configurator to V1.5.2 or above. Select the target device "BETAFPV SuperD 2.4GHz RX". 

FAQ

Know More About ExpressLRS

ExpressLRS is an open-source RC link for RC applications. Everyone could find this project on Github or join the discussion in Facebook Group.

Package Includes:

  • 1* SuperD 2.4GHz Diversity Receiver
  • 2* 2.4GHz T Antenna
  • 1* 4-Pin Header
  • 1* 4-Pin Wire Harness
  • 1* Instruction Manual
  • 2* Heat Shrink Tubing

 

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 61918681745

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.2 ★★★★★
Based on 18 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
E
Verified Purchase
Eli Beltran
Massapequa, US
★★★★★ 1
Beautiful, and everything I want it except that the keyboard keys didn’t work😭
Color: Light Pink
I searched and search for the right keyboard case for me. The most important thing for me was to be able to remove the iPad case itself from the whole case and keyboard, and this one was it. Unfortunately, when I started checking the keyboard a lot of The keys were not output in the correct symbol or letters. So defeats the whole purpose of having a keyboard. I returned it and asked for a replacement, thinking that the item was defected, but when I got the New replacement, it was the same thing so I tried to contact the seller, but there was no option to do that. Therefore, I had to return the second replacement keyboard and look for another keyboard cover.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 23, 2026
A
Verified Purchase
Annabelle wilson
Lexington, US
★★★★★ 5
Quality and Functional
Color: Navy Blue, Color: Navy Blue
I was looking for a case that could rotate and includes a keyboard. I have the gen 5 Ipad Air and it fits just fine. The part that rotates is magnetic (pretty strong) so if i just want the part with the ipad, I can just take it off. Keyboard is magnetic and the touchpad is such a bonus. It was easy to connect and every key works (can also change light color). Im also really impressed with the quality of the case, its pretty thick and even the plastic is nice. The navy blue color is also super cute, wish they had a dark red color too.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 13, 2026
E
Verified Purchase
Ellary
Louisville, US
★★★★★ 5
ABSOLUTELY PERFECT - I LOVE THIS!!!
Color: Pink
I absolutely LOVE this case and the keyboard - it’s absolutely perfect in just about every way. If I had to get nit-picky and find something to give feedback on, I would say it is a bit heavy and it is a bit annoying that you have to move the keyboard forward when you want to use it and backward when you want to close up the case but I don’t care, I love it!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 12, 2026
K
Verified Purchase
Kyle K.
Pawtucket, US
★★★★★ 5
iPad case
Color: Navy Blue
Great case, functions well and the keyboard is a nice touch. Would recommend.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 3, 2026
C
Verified Purchase
C. Coleman
New York, US
★★★★★ 5
Quality Case
Color: Pink
This is an All in Pne case. I really like the lavender color with sparkles. It is a little heavier than expected but I still love it!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 18, 2026

recommand products