Energetic 257.5x257.5mm DOUBLE SIDED Textured Black PEI PRO Spring Steel Sheet (Suits Bambu X1/P1 Series)

Energetic 257.5x257.5mm DOUBLE SIDED Textured Black PEI PRO Spring Steel Sheet (Suits Bambu X1/P1 Series)Are you looking to buy an Energetic Bambu Labs X1 257. 5x257. 5mm PEI Coated Textured Spring Steel Sheet Build Plate in Australia? This bed is DOUBLE SIDED NO MAGNET The textured side is BLACK in PEI PRO HF Version The textured sides have the PHASER FPV logo in Red at the bottom These are made by Energetic Please note these beds are made by a third party and NOT by Bambu Labs. Take your printing to the next level with a PEI coated build sheet. Never

Are you looking to buy an Energetic Bambu Labs X1 257.5x257.5mm PEI Coated/Textured Spring Steel Sheet Build Plate in Australia?

• This bed is DOUBLE SIDED
• NO MAGNET
• The textured side is BLACK in PEI PRO HF Version
• The textured sides have the PHASER FPV logo in Red at the bottom
• These are made by Energetic

Please note these beds are made by a third party and NOT by Bambu Labs.

Take your printing to the next level with a PEI-coated build sheet. Never worry about glue sticks, painter's tape, or prints not sticking to your bed again, simply clean the bed with isopropyl alcohol, press print, and when your print has finished flex your build sheet and the print will pop right off. 

Advantages: 

• Never warp & Never rust.

• Easy to get the first layer even for a new user

• Flexible, Removable, stick to magnets very well

• Lasts 6-12 months or more depending on care and usage.

Recommend print temps 

• PLA – 60C

• PETG – 70-80C

• ABS – 100-110C

Product Usage Guidelines 

PLA/PETG/PCTG/ABS/Nylon (General Hard Plastics)

Warning: If you are not careful with your 1st layer you can risk bonding the PETG/PCTG/Nylon to the PEI surface. This will damage the surface. To prevent damage to the surface apply gluestick before printing PETG/PCTG on the PEI

Removal: Make sure your plate is close to room temp (under 30C) before removing parts. If you remove the print when it is still hot it is more likely to damage the surface. Easily remove 3D prints on the printer by removing the spring steel plate, flexing it, and popping the print off. It's simple and makes the print removal process much easier.

TPU/TPE (Flexible Materials)

Recommended printing on TEXTURED SURFACE ONLY.

Removal: Set heat bed to 100°C,  Allow bed to reach at least 80°C, Pull part at the same time as spraying isopropyl around the part to release it from the build sheet then turn heater bed off.

Browse more

• Browse all  Spring Steel Bed Sheets
• Browse all Bambu Lab Filament
• Browse all Bambu Lab X1 3D Printer, Spare Parts & Accessories
• Browse all Bambu Lab P1P/P1PS 3D Printer, Spare Parts & Accessories
• Browse all Bambu AMS Spare Parts & Accessories
• Browse all Bambu Lab A1 Mini 3D Printer, Spare Parts & Accessories
• Browse all Bambu Labs