Energetic 254x254mm SINGLE SIDED Textured Gold Spring Steel Sheet (Suits Voron 250mm)

Energetic 254x254mm SINGLE SIDED Textured Gold Spring Steel Sheet (Suits Voron 250mm)Are you looking to buy a Voron 254x254mm PEI Coated Textured Spring Steel Sheet Build Plate in Australia? This bed is SINGLE SIDED and textured. You can't print on the bare steel side. The textured side is GOLD The textured side has the logo PHASER FPV in Red at the bottom These are made by Energetic Take your printing to the next level with a PEI coated build sheet. Never worry about glue sticks, painters tape or prints not sticking to your bed

Are you looking to buy a Voron 254x254mm PEI Coated/Textured Spring Steel Sheet Build Plate in Australia?

This bed is SINGLE SIDED and textured. You can't print on the bare steel side.

The textured side is GOLD
The textured side has the logo PHASER FPV in Red at the bottom

These are made by Energetic

Take your printing to the next level with a PEI coated build sheet. Never worry about glue sticks, painters tape or prints not sticking to your bed again, simply clean the bed with isoproyl alcohol, press print and when you print has finished flex your build sheet and the print will pop right off. 

Advantanges:

• Never warp& Never rust.

• Easy to get the first layer even for a new user

• Flexible, Removable, stick to magnets very well

• Suits variety of filaments, especially for PLA

• Free clean- just flex the plate a little then take the prints off after cooled

• Fast heater performance, less waiting time after printing.

• A lifetime 3D printer bed

Features

SmoothPEI- 0.2MM thickness with 3M468 tape

Material:

• 100% real Ultem1000（ PEI）amber color, matte surface. - Made in Europe

• This spring steel sheet is flat, flexible, and sticks to the bed magnet extremely well.

• PEI is 3m tape pre-applied, free of bubbles.

Recommend print temps

• PLA – 60C

• HTPLA – 60C

• PETG – 70-80C

• PCTG – 70-80C

• ABS – 100C

Product Usage Guidelines

• PETG/PCTG/TPU– If you are not careful with your 1st layer you can risk bonding the PETG/PCTG/TPU to the PEI surface. This will damage the surface. To prevent damage to the surface apply hairspray or PVA gluestick before printing PETG/PCTG/TPU on the PEI

  Part Removal– Make sure your plate is at close to room temp (under 30C) before removing parts. If you remove the print when it is still hot it is more likely to damage the surface.

  Easily remove 3D prints on printer by removing the spring steel plate, flexing it, and popping the print off. It's simple and makes the print removal process much easier.

Browse more

• Browse all Spring Steel Bed Sheets
• Browse all Ender 3 Spare Parts
• Browse all Printer Spare Parts